You are here

3004-308-2M - I/O cable for TSM-C/IP/Q/S, 2 meters, shielded

Interested in this product?

Product Features

  • This cable has been replaced by the 3004-318-2M
  • Used to connect I/O on select TSM17, TSM23 and TSM34 StepSERVO™ Integrated Motors
  • Shielded for increased noise immunity
  • 2 meters (6.56 ft) long
  • JST 28-pin female connector to flying leads
  • 25 AWG28 conductors plus drain wire
  • RoHS Logo

Not available for new applications. Please call for assistance selecting a replacement.

1-800-525-1609

Product Details

Vertical Tabs

Description

This cable has been replaced by the 3004-318-2M. Note that the 3004-308-2M uses different wire colors than the 3004-318-2M. Special care should be taken when switching between the two so as to avoid mis-wiring the I/O signals to the integrated motor.

The 3004-308-2M cable is intended for use with StepSERVO™ Integrated Motors of the following types:

  • TSM17C-xCG and TSM17Q-xxG
  • TSM23C-xCG, TSM23Q-xxG, and TSM23S-xxG
  • All TSM34

One end of this cable plugs directly into the I/O connector on the StepSERVO integrated motor and the other end is flying leads for easy wiring to a terminal block or directly to a PLC or motion controller. This I/O cable provides access to these important I/O points: all eight digital inputs, all four digital outputs, the analog input, 5V and ground, and encoder output channels A, B+, and Z+. 25 AWG28 wires are shielded with drain wire exiting the flying lead end. See the downloads section of this page for a drawing of this cable that also contains the pin-out table and wire colors.

Request a Quote