Software: Si Hub
Programmer
To receive updates on the Si software
|
|
Click on some areas of the screen to see what they do
|
This is how you enter new lines of commands in your program , by clicking on the small arrow next to the number it will open the function screen (below). With the Hub programmer you can have up to 200 command lines.
To learn more about these functions click here
| Support Information |
Click on this to access support information
| Drive selection |
This will display the drives available in your system.
If you want to change these drives or their parameters, select Change and you will be presented with the following screen:
If you are not sure which drives are connected to your hub, select Scan Drives. This will give information on the drive types connected to the Hub.
| Com Port |
This allows you to select the Com port you are going to use to communicate with the drive.
| Open Save Upload Download |
Here you can Upload and download files to and from the Hub
Programs can be saved to file for future use.
| Limit Definition |
This box allows you to define what happens if an end of travel limit switch is activated.
 |
© 2008 Applied Motion Products.
Website design by DMT Media |
|